Jump to content

tmaxx

Fusion Member
  • Posts

    4
  • Joined

  • Last visited

Everything posted by tmaxx

  1. I am not sure that I have the blower resistor since I have auto climate control. I think I have a blower control module rather than a resistor. Does this sound correct?
  2. I have a 2010 Ford Fusion Hybrid. I live in Indiana, so a heater is essentially during the winter months. A few days ago my heater stopped blowing heat. There was a very small amount of heat coming out of the vents even on max setting. I tried swapping out the heater blower relay with the rear defroster relay in the engine compartment relay box. When I swapped the relays, the heater fan started working agan. I then swapped the relays back to the original configuration and the heater was still working so I wasn’t sure what to conclude. I drove the car for a few more days and the heater worked fine. This morning, I started my car for work and the heater turned on momentarily and then nothing except for a very small amount of heat on max setting. I started off to work and about half way into my drive (20minutes), the heater came on full and worked for the remaining drive. So it seems the heater fan is intermittently working. Any ideas on how I could troubleshoot this or what I should look at replacing? It’s going to get very cold here in Indiana soon, so I don’t want to end up losing heat again! Thanks. One other thing that may or may not have anything to do with this is that I periodically can hear liquid gurgling in the dashboard...
  3. It's got 40k miles. Not under warranty.
  4. The fan when set to max would vary in speed. Then this morning it isn't working at all. 2010 for fusion hybrid. Any suggestions?
×
×
  • Create New...