indifferent

Step one I need to figure out if it has the harness already installed. If so I may tackle it.

How much work was this. Recently picked up a 2020 SE as a third car due to them pretty much giving it away and am contemplating adding them. I am fairly mechanically inclined. Bigger concern is how long it takes i have three little ones so spare time is a premium. Thanks in advance, E

^^ Agreed.. ANy popping noises while turning? Another give away CV joint. This is a manageable DIY job. If brakes/rotors are 3/10 in difficulty this is probably a 4 or a 5 depending on corrosion etc. I did both on my 2011 over the summer.

Best post in awhile. Thanks for the laugh.

For me it was getting it out of the transmission transfer case that was a nightmare.. thank you Michigan Winters

how bad is this vibration??? I have an 11 sport.. 150k miles.. an 8 year old car with that many miles i expect some small degradation of performance and feel.

Damn Frank... Not a bad gig.. sucks it too so long but sounds like they are making it right .. maybe they'll throw in a couple speedway gift cards and free oil changes... That's usual my local dealer does / service department if they f**** up.

Eezy peezy

CV axle? Any clicking noise?

Try...moog 512498. Moog make a good control arm.. No idea about hubs..

One is for the rear one is for the Front. If you are dead set on OEM, i would reach out to your local dealership. Best of luck

^^ Generally speaking it is the ball joints. I have replaced all the control arms twice now. This car eats control arms. Usually when getting into the car you will hear a audible groan. Not to be contrite but your "Mechanic" brother in law should be able to qucilkly diagnose it wasn't the CV.

moaning and squeeking... those are not noises normally associated with a failed CV.. usually a audible clicking while turning. Replace both of mine this year.. neither of them groaned. when do you hear this noise?

I am getting rust in the same spot. 8 year old car in Michigan bound to happen.

O here in Detroit, we don't believe in mass transit .. I don't even get that option. Only reason I did mine be a bit second time I was already having to do wheel bearing hubs and a CV axle. Id just deal with the creaking.