jafisher5

With the 2019 Fusion SE, it seems that the Push to start feature is pretty much standard. Since they car can detect the presence of the key in the cab, would it be possible to enable Intelligent access entry via touching the door handles? Looking into it a bit it looks like the door handles differ on the models with the full-intelligent access package, SEL/Titanium trims. If you were to replace the door handle and find the values to change in Forscan it seems like this feature could be enabled. Anyone attempted this or perhaps have wiring pinouts for the connectors on the door handles and harness that runs through the doors? I'm wondering if the SE trim just lacks the sensor in the door handle to detect the key being nearby, and it would be awesome if we could swap the door handle, and find the valus with ForScan to make this happen. Going to compare some as built data with a simialr spec'd SEL with this feature, I suspect this Driver / Passenger Door modules might have some clues to this, but some wiring pin outs for those door handles would help to know if its just shined up door handle with a bit of chrome trim, or if its packed with some tech inside. I'd also be curious as to what differs with Remote start on the SE vs SEL/Titanium models. The MyFord Pass can start the vehicle via the onboard LTE modem, so is the hardware there to start/stop the car and also unlock and lock it. Im wondering if anyone knows if these trims run on different frequencies with the remotes, or if we just got a vehicle with remote start and just keyfobs without the butotns and maybe a value or two in Forscan to enable?