OUFan22

Where can I find modules for $300? I know 4dtech has them but at $800. Any information on the source for your information is appreciated.

I recently purchased a 2013 Fusion Titanium with the 8" screen but without navigation. Is it possible to "unlock" the existing APIM module to get navigation to work, or do I need to replace the module?

I did use the correct fluid. I just added some fluid because when I drained the fluid I assume that all nine quarts were removed and that must not have included the torque converter and somehow maybe that drained out too, but I am not sure how. The wrench engine light also went off and the transmission started shifting g smoother. I saw on another thread that some people experience some hard shifting and this started doing not a little bit but went away once I added fluid. Still not sure I have the correct amount but it seems to be better. The method I used was simply draining the fluid just like you would drain the engine oil. I removed the plug underneath, replaced the plug and then refilled with Mercon LV fluid. Should I be able to see the fluid level when I look down the rubber hose filler on top of the transmission?

I changed the fluid in the transmission of my 2013 Fusion SE and am not sure how to verify if I have the correct amount of fluid. For the record the car has the 1.6L Ecoboost engine. I take off the fill cap/plug on top and don't see a way to read the fluid level. The manual says that 9 quarts are required. The wrench dash light just came on and I want to see if a low fluid level would be the cause for this general drivetrain dash night to come on. Any advice?