Alfred L

Good afternoon forum, Anyone ever program a blind spot sensor, my right side blind spot not working and diagnostic say the sensor is defective, I found out that it have to be program, ford dealer want $1000,00 for part plus labor. Thanks

Thanks for heads up.

Thanks to everyone for their advice, this evening I vacuum the cooling system and refill, still blower blowing Cold air. I removed the top motor cover, did a visual inspection and saw what look like a bleeder valve so open it and removed the valve, coolant level drop, I tap up and start the motor, coolant shot out, I shut motor off and screw in the valve and start the motor, run it for about a minute then remove valve again steam comes out, tighten the bleeder valve start the car, as soon as the motor start running I heard a loud clicking sound and suddenly hot air start coming out of the vent, now car is working great again, I ask a Ford mechanic on just answer about the bleeder valve, he told Me that my car don't bleeder valve. Thanks for all the help.

Thanks I'll

I drain the system before I remove the water pump, the coolant didn't drop in the tank. I add 1.5 gallon before I start the motor. Thank for your response.

I'll, all the parts is from Ford I'm going to vacuum the cooling system, if that don't work then I'll replace the thermostat. Thanks

I did it myself, water pump was leaking and the car have 96, 000 miles so I decided to replace all 3, the car was working great before the repair, you think I should vacuum the cooling system?

Thanks for replying, the water pump was leaking, the car have 96, 000 miles so I decided to replace all 3

Hello everyone, I'm a new member, I have a 2010 fusion hybrid just replaced water pump, tensioner and belt. Drain and fill antifreeze/coolant, now motor is overheating and heater blowing cold air. Anyone ever have or know how to correct this problem. Thanks, Alfred