wmbeckham1of3

In my 2010 fusion, the heat does not work anymore. Likely because the blend door is stuck. I went down under and I can't even turn the little knob for the door, If anyone knows what is wrong and how to fix it, please let me know! Would hate to go another winter without heat! Thanks

Went to firestone a few weeks ago and they quoted me nearly $600 to replace the sensors which is insane! I should try around and see what other places would charge. I wouldn't spend more than $200 on this to be honest which is why I may try to do it myself. But yeah I'll ask around and see what I can find! Thanks for the reply!

Over the past year, every time I turn on my car, on the dash it says "tire pressure sensor fault". I finally have decided to do something about it! Did a little bit of research and saw that the problem is likely dead batteries in the sensors inside my tires. (If there could be any other reasons this error is showing please let me know). So before I go and spend $100 on a set of 4 from amazon, does anyone recommend some that are good to use? Also, how exactly would I go about Re-training them for them to work properly after installed? Any help would be appreciated, thanks

Thanks, was able to stick a clothes hanger in the hole. Not sure if it did the trick or not but I watched that video and it was helpful! Do you know how I would tell if it worked or not? Maybe by turning the ac on full blast and looking down at the hole to see if liquid is dripping out? Someone else recommended me changing the cabin air filter. I believe I did that about 2 years ago, not sure if now would be a good time to replace it or not. I did just check the filter and it did look like it should be replaced but I doubt that would be the main thing causing the problem.

Over the past couple months, I have noticed liquid getting into the passenger floor board of my 2010 fusion.... Obviously this is more than likely the AC condensation leaking because of the drain being clogged. This is likely due to me always parking under a tree at most time which likely caused it to get clogged. I've done my fair amount of research to figure out where the drain line is but I just can't seem to find it. I'm sure its pretty far down under the hood. And if someone does happen to know where it is, what would be the best way to go about un-clogging it? I seen people used canned air, just spraying it into the hole?