Search the Community
Showing results for tags 'control module'.
-
Hello everyone, this is my first post on here because I am having an issue diagnosing an ac problem on my girls car. 2011 fusion se 4 cyl manual climate controls. The a/c was intermittent for awhile working only sometimes. Not the only time it will work is if I adjust the temperature knob to hot and then back to cold, It then will only work for about 15 seconds before turning to hot again. I have checked the freon and the system is charged. The compressor clutch is also engaging. I have seen this problem in some topics on here but no one has given an answer as to what the problem was. I am assuming by process of elimination that either the blend door actuator or the control module has gone bad... Any one have any ideas or experience with this
- 5 replies
-
- blend doorac
- a/c
-
(and 6 more)
Tagged with:
-
Just picked up a '12 Fusion SEL fully loaded and now experiencing ambient lighting issues. This car was involved in minor flood issues (to the floorboards) but since has been restored. My issue that the ambient lighting system was originally only displaying a few colors and they were all different (ex. red on one light and white on another light) and this would change after pressing the button. Now, there is NO lights (cupholder or anywhere in the cabin). What could be causing the ambient lights to work sporadically and now not at all? Is this issue repairable by myself? Note: I found an "Ambient lighting control module" on eBay, which was attached to under one of the cupholders when I took apart my center console. Could this be the issue, or something with the wiring? Any suggestions much appreciated!
- 4 replies
-
- ambient light
- lighting
-
(and 4 more)
Tagged with: