Search the Community
Showing results for tags 'lower control arm'.
-
Good day folks! I have a question regarding my brothers Fusion. He just changed his tires and his alignment got refused as his right lower control arm is shot (i assume the inner bushing went to hell). Firstly, does anyone have a write up on how to do it? As I understand the procedure is different in 2013+ Fusions compared to the older platform shared with the Mazda6. Secondly, other than calling a dealer to be certain, there are two part numbers that according to part websites fit: GS7Z-3078-B and GS7Z-3078-A . Any difference between the two? Thank you for your help, Odi
- 1 reply
-
- fusion
- control arm
- (and 6 more)
-
HELP!!! I have a 2010 Ford Fusion SE 4 cyl 2.5L and I had some noise in the front end. Mechanic said it was the CV Axle and the Ball Joints which caused the cv axle to come loose. Upon further inspection he realized the lower ball joints were bad too. So, I went out and bout the upper control arms and two lower control arms (rear I believe as these are straight). Anyhow, one side went on without a hitch and is fully reassembled but the other side is giving him nothing but grief as he can not get the bolt (he said the one that connects to what he thinks is the sway bar or stabilizer bar). He has tried to rethread, he has tried a bigger bolt. All to no avail. Does anyone know how to get this bolt issue taken care of so I can have my car back and so he doesn't age years over the repairing of this car?
- 4 replies
-
- lower control arm
- bolts
-
(and 1 more)
Tagged with: