Search the Community
Showing results for tags 'rear'.
Found 7 results
-
I have a 2010 Fusion SE with a sunroof. Below both rear doors by there is an unusual amount of rust compared to the rest of the car. (About a 3x12" hole / damage) I'm wondering if the sun roof drains in this area for two reasons. One is that the cause? And two I plan to do a very backyard rust repair where you use expanding foam to fill in the huge hole and I don't want to clog the sunroof drains. I'll probably end up running water down the drain to see where it starts draining but if you know, it would make me feel better to know ahead of time!
-
Hello there, What do you think on this funny issue: I bought a fusion se 2014 with 91k miles. Since I bought the car, the rear camera is not working, I thought it was a matter of replacing the cam. Called my attention that every time I go to a highway and then try to park, the camera just works and only works once, for the best twice. The error always states the camera is not available and contact dealer. Thanks for your help!
-
The rear bumper on my 2010 Fusion is sagging about 1/4" compared to other fusions. Is there any way this could be fixed?
-
I have a 2010 SE, with the 6 speaker sound system. The rear deck already has the cutouts necessary to install a pair of 6x9s, all I would have to do is cut insulation. I was wondering, has anybody already attempted this install? If so, how should the hookup and wiring be done?
-
My 2009 Fusion recented starting giving me the message "check brake system" in the message system. The rear brakes were way overdue for pads and rotors so I went ahead and replaced them. I believe it was done right and the brakes seem to be working fine, but the error message hasn't gone away. Does this need to be reset somehow? What does this message actually mean? There is no pad wear sensor in this car that I'm aware of...? The brake fluid level is fine, the parking brake is working, and for the record I am not referring to the "brake fluid low" or "parking brake engaged" error message. I asked about this at the dealership and they did not know what the message meant or how to fix it (how is that even possible?) I tried disconnecting the battery. If anyone knows how to reset this message, or what specifically in the brake system I need to check when seeing this message please let me know. any help would be much appreciated! thanks, ~Dan -
Just picked up a 2012 SEL and noticed the rear windows go up very slow. They start upward, almost stop halfway, then shut. The motors just sound very weak. Both are slow, but the driver side is the worst. Thought of taking it to the dealer but I really dont want my doors torn apart. Anyone else with this issue?
-
Hello, everyone new to the forum because I cant find this answer anywhere...I'm having a hard time finding the specs of the audiophile amp in the 2008 ford fusion se. Besides the fact that they won't fit correctly (I'll worry about that part) does the factory amp have enough juice to power kicker 8" free air woofers 2 ohm in the rear deck? {C}http://www.crutchfield.com/p_206C82/Kic ... tml?tp=111{C} I really don't want to rewire and change any amps. I just sold off a blazer that had two amps, 2 12" punch subs, polk components..it was loud. I want something very suttle in here and I don't want to have to worry about upgrading the whole car. The other option would be the tang band free airs (which don't fit either) but I think they are 4 ohm (not sure if that will work) and would it be an upgrade? Thanks for any help you can give
