Search the Community
Showing results for tags 'screw'.
-
I was trying to change the license plates on my 2006 Ford Fusion and was unable to remove one of the rear screws because the screw hole/mount is loose. Whenever I try to turn the screw to loosen it, the screw and the hole/mount all turn together, preventing the screw from unscrewing. How can I fix this? I was thinking maybe if I could access the backside of the screw hole/mount I could somehow tighten it, but there is a felt/fabric covering on the upper interior of my trunk that I cannot figure out how to remove. It seems to be secured with these plastic rivets. I can post pictures if necessary. It's made of the same material as the rest of the trunk interior. Can anyone tell me how to fix this?
-
So I noticed an air leak in my tire which is about 10 PSI a week. First visual inspection showed no obvious problems so I refilled the tire back to 38PSI (3 PSI over the recommended pressure). But a week later my dashboard yelled at me again that I have a low pressure. So I took it to the tire shop where they found a screw and that they have to replace the whole tire since it's in the sidewall. It's going to cos me $218 with rotation and ballancing - ouch. The screw is really in the sholder and so I wonder if replacement is really necessary. Please check out the picture and let me know what you guys think as $200 is a lot of money for me, but I also don't want to negotiate my safety. I'm talking about Ford Fusion Sport 2012 with GoodYear Eagle tires.
-
I recently replaced the spark plugs in my '07 V6 fusion and when I went to put the manifold back on I guess I used a little too much force and a bolt cracked, is there a way for me to remove the broken bolt from the upper intake manifold? I know I can drill out the bottom half of the bolt, just don't know how to get the top part out. Is it threaded in both directions?. Thanks!
- 4 replies
-
- intake manifold
- screw
-
(and 1 more)
Tagged with: