ramblinbob74 Posted February 4, 2016 Share Posted February 4, 2016 My 06 fusion se has been a good car, until recently. It has been throwing a PO715, input turbine shaft sensor. I've replaced the input and output shaft sensors, flushed the transmission fluid a total of 6 times. Twice cleaning debris out(used mercon fluid) and 4 times using the correct fluid to get the Mercon out... All this changed nothing. So my next endeavor is to check the wiring. My question is, how is the best method to do so? The sensors on my fnr5 are 3 pole. Thanks in advance. 0 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.