2wheelfusion Posted January 22, 2017 Share Posted January 22, 2017 Hey guys, I Have a question about pulling a 3.5L fusion engine out from the top instead of from the bottom. I have seen a few videos on you tube that claim its possible but haven't showed how. does anyone know of a write up someone has done by pulling it from the top? also swapping a fusion engine all together, any tips of hints I should know about? I looked around the forum but really haven't seen anything about engine swaps.Thanks for any help 0 Quote Link to comment Share on other sites More sharing options...
jlong Posted January 23, 2017 Share Posted January 23, 2017 When my water pump was replaced the shop took it out the bottom. I would be interested to see someone pull it out the top but good luck. You'll probably end up having to remove exhaust manifolds, and pretty much all the accessories. A better question might be how high does the front end need to be to drop the engine! 0 Quote Link to comment Share on other sites More sharing options...
akirby Posted January 24, 2017 Share Posted January 24, 2017 They all go in from the bottom on the assembly line. 1 Quote Link to comment Share on other sites More sharing options...
cccerbeus Posted November 1, 2017 Share Posted November 1, 2017 On 1/23/2017 at 7:38 PM, akirby said: They all go in from the bottom on the assembly line. But, they go in as a complete assembly.. If just replacing the engine (like I may have to do) maybe topside access would work.. I'm trying to figure this out myself 0 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.