Sontours Posted July 14, 2020 Share Posted July 14, 2020 I have a 2008 Milan that I am working on. The PO had been having trouble trying to get it working right so I have my hands full. The car starts just fine and idles pretty good with a very slight shake. When you put it in gear you can get moving but the car will not accelerate. The throttle responds and tries to increase speed but very little. I managed to get up to 28mph by letting off the gas and allowing the trans to shift but it just fights any acceleration. When stopped I cannot rev above about 2400rpm where it just struggles and fights back. The battery had been disconnected so there were no codes listed. I am using Forscan btw. The only code I get now is P1719 which is for torque signal. All could and plugs are new from previous owner. They had Ford replace the PCM last fall. I swapped in a known good throttle body and told it to relearn adaptations but nothing changed. Fuel pressure is normal, I help my hands on the exhaust pipes and have plenty of pressure fighting me so at the moment I don't think I have clogged cats. All fuel trims appear to be normal as do the throttle position readings etc. I am sort of at a loss as to what next. I don't give up on things so I will figure this out but I am not wanting to throw parts at it until I have a good idea what will work. Any thoughts or similar experience? Could this be Limp Mode that it is stuck in? If so, would I get a code for that with Forscan? Thanks for any ideas. P.S. can I post a video of how it runs? Phil 0 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.