ABS, brake, traction control lights on

[Optics406]

I  have a problem that I cant seem to figure out on my 2013 Ford Fusion SE 1.6L Turbo

 

The ABS, brake light, and traction control lights are all illuminated. They all lit up after I replaced a broken ECT pigtail that simply fell off and triggered a couple DTCS.

After replacing the pigtail for the etc, the dtcs are now gone, so I consider that problem fully fixed.

 

When I run the self test for the abs module no dtcs are found but when running the self test for the PSCM this code is found:

DTC ===PSCM DTC U0415:00-0A===
Code: U0415 - Invalid Data Received from Anti-Lock Brake System (ABS) Control Module A

I am using Forscan as my tester.

 

I am wondering when the ect pigtail broke it shorted and destroyed my ABS module or smoked another wire leading to the ABS module.

Any suggestions for fixing this issue would be appreciated and if anyone has the wiring diagram for the abs module would be very helpful so I can atleast check the harness power and ground pins.

 

I attached a couple files to this post. One is the DTCs from forscan and one is a picture of my dash lights while engine is running.

I also have dtc ===FCIM DTC U0253:00-0A===
Code: U0253 - Lost Communication With Accessory Protocol Interface Module for many years and the speakers sometimes dont work but not sure if they are linked with the other dtc.

 

Thanks

 

DTC_2020-11-04_13.49.59.txt.txt

[Pritsch]

I have some procedures here that might work. Did you solve the problem?

It's for the 2011 fusion but i do believe they work for your model. You would have to check it yourself. I can give you the procedures if you want to. 

 

 

And the diagrams for the Module Communication Network. I think that's what you need. The ABS is the last one. Do pay attention as this is the manual for the Fusion, Milan and MKZ so you have "equal" diagrams for different cars.