Abbby Posted December 27, 2020 Share Posted December 27, 2020 2010 MKZ AWD - I replaced the 3 piece driveshaft last week with a new 2 piece. Had read that I needed to unhook the front exhaust connection and drop the exhaust. I was able to replace the shaft without completely dropping the exhaust. I disconnected the two middle rubber exhaust supports and was able to lower the exhaust just enough to slide the old axle out the back and then slide the new one back in. 0 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.