Jump to content

VSS Replacement Info : 2010 6MT Fusion


perkele
 Share

Recommended Posts

wanted to share my experience (and replacement part numbers) for anyone googling or searching the forums about VSS issues.

 

vehicle : 2010 Fusion 2.5L 6MT

 

symptoms : P0720 code. speedometer intermittently not working. speedo eventually stopped working completely. CEL started coming on. car would go into limp mode (reduced acceleration) and occasionally even stall at idle.

 

i noticed that the VSS connector cable was almost completely gone (note corrosion in the photo).  there was not enough wire to properly solder/repair it so i ordered a new connector pigtail from the dealer.  this did NOT solve the problem.

 

next, i ordered a new VSS from Rock Auto. a bit of PB blaster to get the old sensor out and i was able to remove and replace the sensor (remember to put some gear oil on the o-ring before installation). problem solved! the old sensor was cracked (see photo)

 

my only theory is that the sensor and the connector were damaged when the clutch was replaced a while back (?) even though the car was fine when i got it back.

 

anyway - hope this helps someone.

 

VSS OEM Part Number :

  • 17271 (from service manual)

 

VSS Connector Pigtail OEM Part Number :

  • 3U2Z-14S411-DLAB / WPT-1021
    (the parts counter had a really tough time finding this)

 

VSS Aftermarket Replacement :

  • Brand : WVE
  • Part Number 5S16505

 

Damaged VSS Connector Wiring (the wire fell apart when I removed the connector, but note the corrosion and damaged insulation) :

 

broken_original_VSS_pigtail.jpeg

 

 

Replacement VSS Connector Pigtail :

 

OEM_VSS_pigtail.jpeg

 

 

Broken Original VSS (note the dents and crack at the base - guessing this happened when the shop replaced the clutch a while back) :

 

broken_original_VSS.jpeg

Edited by perkele
photos
Link to comment
Share on other sites

  • 2 months later...
  • 1 year later...

Hi Mister,

 

I was so happy to read your diagnostic and fixing solutions .... I'm struggling for the same problem fo a year now... I've changed a lot of small parts and was about to change de VSS... but was hesitating. Can you tell me where on the engine the VSS is fixed ? 

 

Thank you so much for sharing 

 

Ben 

Link to comment
Share on other sites

8 hours ago, Benny D said:

Hi Mister,

 

I was so happy to read your diagnostic and fixing solutions .... I'm struggling for the same problem fo a year now... I've changed a lot of small parts and was about to change de VSS... but was hesitating. Can you tell me where on the engine the VSS is fixed ? 

 

Thank you so much for sharing 

 

Ben 

The VSS is not mounted on the engine.  It's mounted on the transmission where it can monitor output shaft speed.  Location may vary depending on which transmission you have.  Note that this thread concerns the 6-speed manual trans, only available with the 2.5L engine.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

 Share

×
×
  • Create New...