Nsrawlings Posted December 18, 2022 Share Posted December 18, 2022 My ford fusion 2010 is missing the blend door actuator motor. My question is if I order a new one does it simply install into this spot or is there a piece that’s missing? 0 Quote Link to comment Share on other sites More sharing options...
Grampy Posted December 20, 2022 Share Posted December 20, 2022 I'm impressed you are able to get that picture. I just replaced one on a 2015, they look like this..(the one I replaced on my 2002 Explorer looked very similar) So based on our picture, align the new ones operating shaft & put it in, put the bolt(s) / screw(s) in and plug it in.. I have the 2010 shop manual, if you need any additional information. 0 Quote Link to comment Share on other sites More sharing options...
Fuser Posted December 8, 2023 Share Posted December 8, 2023 How can you get to the blend door? The actuator on my 2012 works. The blend door is stuck. Last spring, I was able to turn the little knob by hand. Now that we have cold weather cannot turn the knob to move the blend door back to divert warm air to the vents. Cannot even find a picture of the blend door. Wonder if I could buy one. 0 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.