stanleyi4se Posted December 12, 2006 Share Posted December 12, 2006 I really like the headlights on the mercury milan, i was wondering if they are interchangeable with my fusion's headlights??? anyone know if this is possible??????? 0 Quote Link to comment Share on other sites More sharing options...
robertlane Posted December 12, 2006 Share Posted December 12, 2006 Good question. Someone posted a website with after market headlamps. If they use the same part# for the Fusion and Milan, then they should interchange. Anyone? 0 Quote Link to comment Share on other sites More sharing options...
4.6fox Posted December 13, 2006 Share Posted December 13, 2006 I was at the ford training center today for CVT school and was parked next to a milan. Im not sure it will, looks like the hood is different, but its hard to tell 0 Quote Link to comment Share on other sites More sharing options...
SCOTT07AWD Posted December 13, 2006 Share Posted December 13, 2006 It looks like the Fusion headlamp goes further back into the hood than the Milan headlamps do. So I don't think that they are interchangable. 0 Quote Link to comment Share on other sites More sharing options...
Cobra Dan Posted August 15, 2007 Share Posted August 15, 2007 to add Milan headlights to your Fusion, you'll need to utilize a Milan front bumper cover and hood. 0 Quote Link to comment Share on other sites More sharing options...
Meelaan Posted August 15, 2007 Share Posted August 15, 2007 to add Milan headlights to your Fusion, you'll need to utilize a Milan front bumper cover and hood. Correct. It's not simply a matter of "can those headlights go on that car." Any part adjacent to the headlights is affected. 0 Quote Link to comment Share on other sites More sharing options...
fordnut Posted March 19, 2008 Share Posted March 19, 2008 Correct. It's not simply a matter of "can those headlights go on that car." Any part adjacent to the headlights is affected. The headlights by themselves are not interchangeable. 0 Quote Link to comment Share on other sites More sharing options...
ethan Posted May 26, 2010 Share Posted May 26, 2010 (edited) hi, i own a 2008 milan, i know this is slightly off topic, but i have scanned the internet a rediculous amount of time looking for anyone who's been looking at this too. do you all think/know if the grills, to a 07 fusion would fit a 08 milan? they look super close, however i think the curve of the bottom right/left is tighter on the milan, or less curved. Edited May 26, 2010 by ethan 0 Quote Link to comment Share on other sites More sharing options...
bbf2530 Posted May 26, 2010 Share Posted May 26, 2010 (edited) hi, i own a 2008 milan, i know this is slightly off topic, but i have scanned the internet a rediculous amount of time looking for anyone who's been looking at this too. do you all think/know if the grills, to a 07 fusion would fit a 08 milan? they look super close, however i think the curve of the bottom right/left is tighter on the milan, or less curved. Hi ethan. :D No, it is not a "plug-n-play" swap. Among other factors, if you look closer you will see that the Fusion grill is noticeably wider. It would need cutting and fabrication to fit. Good luck. :beerchug: Edited May 26, 2010 by bbf2530 0 Quote Link to comment Share on other sites More sharing options...
akirby Posted May 26, 2010 Share Posted May 26, 2010 Hi ethan. :D No, it is not a "plug-n-play" swap. Among other factors, if you look closer you will see that the Fusion grill is noticeably wider. It would need cutting and fabrication to fit. Good luck. :beerchug: Probably be easier to swap out the entire front clip sheet metal (hood, fenders, bumper, grille). 0 Quote Link to comment Share on other sites More sharing options...
ethan Posted May 26, 2010 Share Posted May 26, 2010 yea, i was afraid that was reality. they sure do make the dash components similar! i think i'm going to do a mesh grill like that image of the milan i posted above, only i'm not going to add the logo in again. i'd be happy with it if the logo wasnt there in the existing grille! ha... now to research how i go about doing mesh grille backings well... i'm very clever but on we go... 0 Quote Link to comment Share on other sites More sharing options...
ocsoofficer Posted June 5, 2010 Share Posted June 5, 2010 yea, i was afraid that was reality. they sure do make the dash components similar! i think i'm going to do a mesh grill like that image of the milan i posted above, only i'm not going to add the logo in again. i'd be happy with it if the logo wasnt there in the existing grille! ha... now to research how i go about doing mesh grille backings well... i'm very clever but on we go... ethan, did you ever make that mesh front grill for the Milan? The above posted pic of such type mesh grill looks real good and I would love having one on my Milan... 0 Quote Link to comment Share on other sites More sharing options...
VEBRA Posted October 14, 2023 Share Posted October 14, 2023 Do 2005 Ford Fusion headlights fit a 2007 Ford Fusion ? 0 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.